Motor Speed Controller Dimmer 240Vac / 110Vac, 25 Amp M028N

Power & Speed Controller 110V / 240V

Manufacturers Notes...M028N

Loads of applications and with a 25 amp peak rating! With this power controller you can regulate incandescent lamps, heaters, heating lelements, hand drills, electric motors etc. via the supplied potentiometer. 2 operating voltages: 110vac or 240vac. The rated contstant load is 18A but can peak at 25A max. At 240vac this corresponds to 4000va. The units are PWM (Pulse Width Modulation) type controllers.

Important Note: The module HAS to be mounted on a heat sink or cooling plate if the constant load exceeds 8 amps.

Single phase motors with internal centrifugal starting switches can not be speed controlled electronically.

If it is a DC appliance that needs to be controlled, the module can be installed at the primary (input) side of a transformer which in turn will give a proportional output on the transformers secondary (output) side, thus allowing full control over the DC output too. Perfect for loads of power, voltage & speed control applications.

The power controllers are supplied with the potentiometer & leads

Technical data...

• Operating Voltage: AC 110...240V, 50...60 Hz
• Max. Current: 25A (constant duty: 18A WITH HEATSINK)
• Max va Rating: 4000va at 240vac / 2000va at 110vac
• Duty cycle: 100% at 18A
• Control: Via Rotary Potentiometer
• Loads: For ohmic or inductive loads
• Dimensions: approx. 86 x 60 x 33 mm