Water Pipe Descaler Unit, Water Conditioner BCT101

A simple cost effective solution to help prevent and remove limescale build up.

What is included in the box:

• 1 x BCT101 Magnetic Field Generator (Descaler)
  
• 1 x 10 Meter Adaptor Extension
• 1 x Plug-in Power Adaptor
• 1 x Mounting Accessory Pack

How it works:

The magentic Field Generator allows lime molecules (calcium, magnesium and manganese salts) to flow freely through the entire water system helping to prevent bonding of the molecules to the pipework, which causes restrictions & blockages. Due to the low frequency induction, the water flowing through the pipe is subject to constantly varying magnetic fields which will alter the distribution of the electric charge on the limescale crystals allowing them to flow freely and not bind to surfaces. Existing water pipe systems (over time) will begin to clear once the BCT101 has been installed and a marked difference will be noticed to shower heads, kettles and boilers heat exchangers due to lime scale molecules being allowed to flow freely through the system and also remove existing build up in the process. Cleaning shower heads and taps will be easier too. The process is made possible by using a low frequency impulse that positively charges the lime molecules which prevents them from attaching to the wall of the pipes.

Major Benefits:

• No chemical changes to your water
• Less Boiler Maintenance
• Prevents scale build up in all water pipes
• Easy to install, no DIY experience necessary
• Descales existing 'scaled up' water systems
• Very cheap to run

 Installation:

Installation of the BCT101 Water Pipe Descaler is very straight forward. Simply find a place closest to main water inlet (indoors only), carefully wrap each of the cables in opposite directions around the water pipe allowing a 4 cm gap between each coil and secure the ends with the supplied cable ties. The unit can be mounted to the wall with the supplied screws or can be left supported by the coils. Plug in the supplied 10 meter extension into the BCT101 unit and the other end of the extansion into the power adaptor. We provide the 10 meter extension to allow for routing the power supply to a nearby power outlet. The unit can  be used on Plastic, Copper or Metal pipes up tp 80mm diameter but we do not recommend using it on lead pipes.

Technical:

• Operating Voltage: 6 To 16Vdc (230vac To 12vdc power adaptor included)
  
• Power Consumption: Less than 130 Milli Amps
• Operating Frequency: <2000 Hz
• Suitble For Materials: Copper Pipes / Plastic Pipes / Metal Pipes
• Pipe Size Range: Effective for water pipes from 6mm To 80mm Diameter.
• Water Capacity: Up tp 5000 Litres Per Hour

The units are an environmentally friendly alternative to harsh chemicals and also expensive pipe and equipment replacement.